the ring

My wife lost her wedding ring. It slipped off her finger during a swam on a beach where we use to go.
The waves movements quicly make it illusive to get it back.
By way of vengeance, I picked a pebble on the beach and made her a ring out of it.
Here are the steps of the design :

The pebble (doesn't wonder what will happen to him)

The same one, sliced

To avoid to much sanding, after marking the inside diameter of the ring, more cutting

Here comes the hollowing out

The inside is sanded, time to even up the outside and to polish it all

The ring finished, all angles polished to avoid sharp edges, only the varnish to get done

And my wife's hand has a new ornament, phew, the worst has been avoided :-)

Eclipse

Back to work on paper.

A little pic of my ongoing work...

To be continued...

stuff

Still no time (or desire?) to start new and large works, so I do little things while testing electro-etching.

A new filigree pattern, a bit smaller than the first one :

And a new seal made from a bolt, this time using a new and more little one :

slate engraving

You know about my obsession for filigrees and my yearning for engraving, here is a little try mixing both with a pattern I invented engraved on slate with a simple nail.

The pattern is approximately 2cm large, now that I proved that it is possible, I can try more ambitious works :-)

rust & vine

After quite a long time under the rain, followed by a scraping, more rain and a final sanding, I still can't get the expected result from the plate I already told you about here.

It's not bad, it's just that I was waiting for something else.

I think it will go back to rust in the garden :-)

50%

I've just finished two little brooches (approx. 2.5cm in diameter) and failed the etching of one of them :-/

The knotwork I made with acid etching and the filigrees with electro-etching. This one got eaten on the edges and I'll have to redo it. 50% of success, I have to improve the ratio :-)

Bolt

Digging in the garden, I made an almost archeological discovery, an old bolt eaten by rust. I cleaned it a bit, not too much for the patina to remain and, as I found it really beautiful, I decided to find another use for it.

I turned it into a seal by electro-etching a man hole cover pattern on his head.

And the result is perfectly functional as you can see.

This is how to turn rubbish into design and original object :-)